Laser Beam Machining
What is the full
form of LBM in advanced machining processes?
a) Laser Beam
Manufacturing b) Laser Beam
Machining c) Light Blast Manufacturing
d) Light Beam
Machining
View Answer
Answer: b
Explanation: The
full form of LBM is Laser Beam Machining in the advanced machining processes.
LBM offers a good
solution for which material properties below?
a) Thermal
conductivity b) Specific heat c) Boiling temperature d) All of the mentioned
View Answer
Answer: d
Explanation: LBM
offers good solution for material properties such as thermal conductivity,
specific heat, melting and boiling temperatures.
What is the
abbreviation of Laser?
a) Light allowed
simple emission of radiation b)
Light amplification by stimulated emission of radiation
c) Light amplified
simultaneous emission of rays d)
Light amplified stimulated emanation of rays
View Answer
Answer: b
Explanation: Full
form of laser is Light Amplification by Stimulated emission of radiation.
Which of the
following are the properties of a laser?
a)
Highly collimated b) Monochromatic c) Coherent light beam d) All of the mentioned
View Answer
Answer: d
Explanation: Highly
collimated, high monochromaticity and the coherence of the light beam are the
properties of a laser.
Laser beam machining
uses which type of power sources for machining?
a)
Very low power b) Low power c)
Medium power d) High power
View Answer
Answer: d
Explanation: High
power densities are used for the generation of laser and for machining in Laser
beam machining.
Which of the following
is not an advantage of LBM?
a)
Rapid machining b) Low operating cost c)
High equipment cost d) No tool wear
View Answer
Answer: c
Explanation: Rapid
machining, low operating cost and no tool wear are some of the advantages of
Laser beam machining.
Which of the
following systems is used for locating the hole accurately for alignment?
a) Mechanical
control system b)
Optical laser system c)
Measurement system
d) Alignment system
View Answer
Answer: b
Explanation: Holes
can be accurately located using optical laser system for alignment in Laser
beam machining.
Very _____ holes
with a _____ aspect ratio can be produced using Laser beam machining.
a)
Small, small b) Small, large c) Large, small d) Large, large
View Answer
Answer: b
Explanation: In
Laser beam machining, very small holes with large aspect ratios can be
produced.
How are the
machining times in Laser beam machining?
a) Very slow
machining times b) Slow machining
times c) Moderate machining times
d) Fast machining
times
View Answer
Answer: d
Explanation:
Machining is very much rapid and the setup times are economical in Laser beam
machining.
Ref: https://www.sanfoundry.com/advanced-machining-questions-answers-edm-applications-1/
R.Satheesh
